Description

Mostly for gaming but I am also in an engineering academy and will be using it for things like Revit and Inventor. Everything works great!

Comments

  • 23 months ago
  • 1 point

Nice the area looks very clean and the build mostly looks good as well. Just a tip get some velcro cable ties for those extra wires.

  • 23 months ago
  • 1 point

Thanks! I really just wanted to finish the build as fast as I could because of the limited time I had. When I get back in town I plan to reorganize the wires.

  • 23 months ago
  • 1 point

Oh ok.

  • 23 months ago
  • 1 point
  1. How are your fans configured? I see 4 fans in the case (including the one with the radiator). Which one of these are intakes and which ones are exhausts?

  2. Will you overclock the CPU?

  3. Have you enabled XMP in the BIOS?
  • 23 months ago
  • 1 point
  1. The two on the right and the one on the top are intake and the one to the left of the motherboard is an exhaust. I did very little research with fans and would love some good criticism.

  2. I do plan on overclocking in the near future.

  3. I have not but I am researching this right now!

  • 23 months ago
  • 1 point
  1. If the picture reflects the current state of your fans, then the front fan above the radiator is an exhaust. I wouldn't do that. The front bottom fan (radiator) takes air and releases warm air. Then the front top fan (above the rad) pushes this warm air outside toward the front which will be taken by the radiator fan once again. Kind of a feedback loop.

A typical configuration would be that the front is all intake, the rear and top are exhausts.

As for the XMP, it's rather easy. Just have to enable it in the BIOS and there you go. :)

  • 23 months ago
  • 1 point

Thanks!

[comment deleted by staff]
  • 23 months ago
  • 1 point

Finished it this week!