Description

Build I just completed. It's all AMD, All 7nm, All PCIe 4.0 with a 280 Kraken X62 in Push/Pull Noctua Industrial fans. Stuffed into a NZXT H210.

The case only fits a 240 AIO. It will fit the X62 but you have to take out the wire rail, top fan and whole front assembly to get it in. Install is much harder so while it isn't as easy as going with the X52 240. It will fit.

This is my All-in-one, Workstation/HTPC/Gaming PC.

Log in to rate comments or to post a comment.

Comments

  • 5 months ago
  • 1 point

Do you think to performance would have suffered with the 240 rad? Sick build stuffing a massive CPU and GPU in this tiny box.

  • 5 months ago
  • 2 points

Honestly I think in a normal environment like sitting on a desk in a reasonably cool room it would be fine. If anything this case would choke the GPU more than anything. Especially if you only had 2 120mm fans in push config at the front.

I have this sitting in a media closet and live in Phoenix, AZ so in the summer the closet can be closer to 90 degrees (32c) so I wanted to make sure that I had more than enough cooling. With the PC sitting about 12-15ft away from where I use the PC noise isn't a factor. So to me the ability to really ramp up these overpowered fans made sense. At the full 3,000rpm though they are audible from 20ft and sound like I have a drone hovering in the closet. I don't let them ramp that high though haha.

For the CPU I think it would run a tad bit hotter but a 240mm AIO would be fine. GPU will take a hit however with the smaller 120mm fans IMO.

Most important thing to this build is the SFX PSU. This smaller PSU allows more air to get to the GPU from the holes in the bottom shroud. Combine this with the steady flow of air from the bottom 140mm Pull fan and it keeps the GPU perfectly cool. A full size ATX PSU would increase thermals of this build to the GPU considerably.

  • 5 months ago
  • 1 point

How much was the CPU?

  • 5 months ago
  • 2 points

$749.99+AZ Tax (Stayed up all night got it from Amazon in the first few seconds it went live) After striking out at Newegg, AMD Direct and Microcenter

  • 5 months ago
  • 1 point

they are retailing for $750

  • 5 months ago
  • 1 point

Did you have to buy after market cables for the PSU? I'm seeing/reading that the stock cables from corsair's PSU aren't long enough?

Thank you!

  • 4 months ago
  • 1 point

Nice compact build. I'm considering something very similar but with with a 2080 Ti graphics card. Hope it works. Thanks for showing your machine.

  • 2 months ago
  • 1 point

I'm also planning to build a m-ITX with a 3950x and a Radeon RX 5700 XT. All these parts are compatible Hackintosh hardware. The Ncase M1 is way overpriced so the NZXT H210 is my second choice.

I see that you have 4 fans (!) on you radiator. Doesn't it fit with 2? Do you need 4 ?

I want to fit a graphics card with a length of 280mm. Yours is 240mm. I saw on youtube (Gear Seekers) that it can be done. Do you think this is going to fit?

  • 1 month ago
  • 1 point

You would have to ditch the push-pull config on the rad and go for a normal 2 fan config if you wanted to fit something larger than 240mm. 4 fans are by no way needed for the rad, they are just to help with CPU temps a small bit. Taking them away should not impact performance too much, at least to the best of my knowledge.

  • 2 months ago
  • 1 point

Couldn't wait for the chromax fans to be restocked? lol

[comment deleted]